Photoshop to create the magic purple make-up beauty

Original

final results

1, open the image, double-click unlock, copy a layer.(Personal habits)

2, began to dermabrasion: Gaussian blur, values 4.0, click on the snapshot, I remember it was called the), back to the previous step, which set the historical record, select the history brush, smear the skin of characters, focusing on the skin spots, Peas, vague as far as possible, but generally not too raw, or else will look very fakeThe.



3, obviously part of the select spots (mainly cheeks, forehead, neck and some other), with the lasso tool (Feather 10 ~15) ring out, copy (of course you can not copy), Gaussian blur, numerical 4.0 ~ 5.0, seem to melt together and the surrounding skin.

4, wiping Blusher: New floor, according to the approximate location of the figure, using lasso tool to Circle (slightly smaller than some, emergence values 10 ~ 15, or greater), and then eclosion, the fill color#825,649, layer pattern color filter.



5. according to the approximate location of the figure, the same with the lasso tool (note: I ring than out of some small number, I amcircle out of the post-emergence), the value is, then eclosion, the fill color #9a333f, opacity 20%.

6, followed by whitening: stamp layers, new layers to adjust brightness/contrast (brightness 10, contrast 25).Mobanggongju circle with some of the skin (except the lips, the facial features do not go in the election), with special attention, as long as part of the skin (see Figure, probably like this a)!



7, lap after a good (if it is lasso tool, then emergence value is 0), ctrl + J to copy a layer, moveBrightness/Contrast layer above the opacity 70%.Comprehensive look at over yellow skin.

8, Tu Lip Gloss: Newlayer, select the Gradient tool, enter the Gradient Editor: Left #aa2a7e right #9515e8, set the following figure:



9, and then a new mappull-layer gradient.Circle the lips part of the anti-selection to delete other parts of the gradient color (which can be an appropriate eclosion), soft layer mode selection, with an eraser tune the excess.

10, followed by eye shadow and hair that is part of: New floor, select the Gradient tool,into the gradient editor: Left #ff00f0 right #6c00ff, set up, such as step 7 of the shots, from the lower left to upper right corner of La gradient, layer modes soft.With the Lasso tool to select parts of the skin (feathering value of 15 or more) del deleted, facial features in the left part of the eye, probably look like the plug-ha.

11, Dream effect: dragged into the material, color filter layer pattern.Because the material than the figure is small, need to change the size, and then copy the layer, or not enough.Rub the skin part, that the result is almost up on it.




This articlesource:Design and Material (http://www.q60.org),copy please specify.