Photoshop to create beautiful blue angel MM

Let us look at what the final results:

1, you'd picture color.

1, Open Original Material, the background copy layer layer, while holding down Ctrl + ALt + ~ tune a high-light constituency, press Ctrl + Shift + I Invert Selection. Create a curve adjustment layer, type: 88/output: 159. The purpose is to raise bright dark picture, while the Ministry of constant light.

2, once again, create a curves adjustment layer, numerical: Input: 88, Output: 163. The character transferred to a suitable brightness of the face. The curve masks filled black, foreground color set to white. Character's face with the brush to wipe out. The purpose is to figure the face bright tone.



3, create a curves adjustment layer, select the green channel, pull down the curve a bit. Value: Input: 113, output: 106. Partial adjustment of the color green. Each time the use of curves is a layer. So far, there are three curves adjustment layer.

4, create a new layer, press Ctrl + Alt + Shift + E stamp layer, using Imagenomic to the picture dermabrasion, the default values.

5, select the menu: image> model> Lab color, select the sub-fight. Point of access panel to a channel to copy to the b channel. Back to the layer, select the menu: image> model> RGB color, select the sub-fight. Color has been done.



2, Cutout.
Cutout There are many ways you can use lasso, magic wand, channels, pens and so on. Regardless of the method used must be carefully add patience. I use a pen out of Canada.

1, in the transfer of sexual lust and create a new map layer, filling brown. Will be transferred layer of sexual lust and three copies, respectively, copies, copy 2, copy 3. This three-tiered Internet onto the fill layer above the layer. Close copies 2 and copies of three in front of the eye. Select pen tool, copy the figures out of the general selection, click on the path panel, select the button to load the path as a constituency. Constituency appears, press Ctrl + Alt + D Feather 1 pixel, press Ctrl + Shift + I Invert Selection, press Delete to delete.

2, open a copy of the two in front of the eyes, with his head out of ways to figure out the edge of the white hat. Open the copy of the three, the character's hair out of the edge. Add a layer mask with a black brush to erase part of the multi-pumping. Click layer> trimming> to the edge, value is 1. The merger of three layers, using the same method to stand-out white.

3, Synthesis.

1, to open early in the morning prepared the background map, the foreground color set to blue: #12dfec, in the Layers panel Select" Create new fill or adjustment layer" in the solid, giving the blue fill layer, layer mode to" overlay" , opacity 55%.

2, the characters fastened onto the background layer on the map, and put in proper position, with the lasso tool to skirt tail elected, and then run: editor> change> deformation. The white skirt stretched until the bushes.

3, the background image bottom left corner of the grass buckle up, put a skirt above the other. With the hardness of the soft angle 0 brush, opacity is set to: 8%, in the skirts of the four sides of the rub gently.

4, the material of cutting out the cat Ali, dragged below the figure due to narrow, and then run: editor> transform> deformation, the cat's tail right up pulling a pull, so that the tail a little Alice. With the color balance to remove the yellow-green cat.

5, use the wizard to add a pair of brush to the figures transparent wings, and then add some of the characters around the bubbles and energy. Should pay attention to proper size and density.

6, repeat the first step in the action, in order to photograph a blue fill layer: #12dfec, add a layer mask to do not need to wipe out of the blue added to complete the final results.




This articlefrom:Design and Material (http://www.q60.org),Reprinted Please note Ming.