Photoshop to create fantastic sea and fresh wedding film

Original



final results

1, Open Original Material, the layer background copy layer. Blending mode to" Linear Light" , hold down the Alt key to add a layer mask with a white brush to wipe out some of the beach.



2, a copy of the background layer to copy a layer, blending mode to" Multiply" layer Opacity to read: 75%. This two-step operation to strengthen the beach when the color.

3, copy the background layer, press Ctrl + Shift +] Top, blending mode to" Color Burn" , press Alt key to add a layer mask with a white brush to wipe out some of the sea. The purpose of this step operation is to strengthen the color of the sea.



4, open the following diagram shows the sky material delay in, Add Layer Mask. With a black brush to erase the unwanted part, the purpose of this step operation is to make the sky full of vigor.

5, create a new layer, change blending mode" overlay" , select the Gradient tool color settings below chart, pulled out the blue to blue linear gradient. Add a layer mask with a black brush wipe away part of the sky. This step is the performance of the sky color.

6 create a new layer, press Ctrl + Alt + Shift + E stamp layer. Select the menu: image> model> Lab color, select the mosaic, and then refine color.



7, to copy the background layer a layer, do: image> application of image manipulation, parameter setting the following picture. Hold down the Alt key determined to add layer mask, with a white brush head in the character of the skin and figure painting at the sky. The purpose is realized characters skin color and facial features the three-dimensional sense of place.

8, create a curves adjustment layer, select the brightness channels, dawn entire photo brightness and contrast, the main purpose or highlight the character's skin color.



9, create a new layer, layer stamp. Into the channel panel, select the lightness channel of: filter> sharpen> USM sharpening, the parameter is set the following picture. And then back to the Layers panel.

10, select the menu: image> model> RGB color, points, merged. Press Ctrl + Alt + 1 transfer out of the red constituencies, creating curves adjustment layer, the parameter is set the following picture. Determined to mask filled with black, white brush on the skin in the figure painting.

11 create a new layer, layer stamp. Executive: image> adjustment> Auto Levels, determined to add layer mask with a black brush will jointly figure.



12, create a new layer, layer stamp. And then some thinning of the characters, here operation is complete.


This articlefrom the:Design and Material (http://www.q60.org),reproduced Please keep this line.